-
-
Connect the delivered loop cable
-
This cable connects shelf and server part of the controller
-
If cable is not plugged the display will keep showing 'Starting up'
-
If the cable is not connected a communication with the shelf is not possible
-
-
-
Management and Data must not be in the same subnet
-
Management and Data may be combined to one interface later
-
Connect 1GB Ethernet to Management port for Configuration via WebUI
-
Connect 1GB Ethernet to IPMI port for hardware monitoring and service access
-
Connect FibreChannel or 10GB Ethernet cable to data port ( depending on ordered hardware )
-
-
-
Start up your controller by connecting the power cables
-
-
-
G5000 will try to receive IP addresses via DHCP on management and data interfaces
-
If no DHCP server can be found G5000 will assign fallback IP addresses as follows
-
Management: 192.168.1.1
-
Data: 192.168.2.1
-
The assigned IP addresses may be checked via...
-
...G5000 EPaper Display
-
...Monitor console output
-
-
-
Open the Webinterface via management ip "https://<ip>/
-
Default user: admin
-
Default password: adminadmin
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein weiterer Nutzer hat diese Anleitung absolviert.