-
-
2 telescopic rails for the device
-
Screw set for mounting the rails on the device and in the rack
-
-
-
The red marked part of the rail points to the front side of the rack
-
The orange marked part is the mounting at the back of the rack
-
Slide rail to which the device is screwed on
-
Pull out the slide rail to the front side of the rail until the rail stops
-
Push the small lever upwards. This releases the rail lock and you can remove the slide rail completely from the equipment rail.
-
-
-
When mounting, the small angle of the slide rail points to the front side of the device.
-
The release lever of the rail points to the rear of the unit.
-
For mounting the 4 small Phillips screws are needed
-
The front hole of the slide rail is used in each case. The rail is flush with the front of the unit.
-
Achten sie darauf die Schauben nicht zu verkanten, da sonst das Gewinde im Geräte Gehäuse beschädigt werden kann
-
-
-
No cage nuts are required.
-
The enclosed mushroom head screw is required at the front of the unit. When mounted, the device arranges in this screw.
-
On the rear side, the enclosed large Phillips head screw is required.
-
-
-
Slide the rail from the inside of the rack against the bracket so that the two brackets are supported in the rack and the screw hole is centered.
-
Screw the mushroom head screw to the rail
-
-
-
Schieben sie die Schiene von der Innenseite des Racks gegen den Träger, so dass die beiden Winkel sich im Rack abstützen und das Schraubloch mittig sitzt
-
Make sure that the front and back of the rail are at the same height !
-
Screw the crosshead screw to the rail
-
-
-
The machine must be inserted so that the FAST logo is on the right side
-
Slide the machine with the mounted slide rails into the rack rails. Be careful not to tilt them.
-
When the rails snap into place, the small levers in the slide rail must be released. Then push the rail in as far as it will go.
-
The mushroom head screw then locks with the device front and secures the device.
-
Fast fertig!
Ziellinie